The hydraulic system of the hydraulic station simply ignores some details in the process of operation and starting, resulting in problems of the hydraulic system. As the manufacturer of the hydraulic system in Yuanye, we will summarize the details that should be paid attention to during the operation and startup of the hydraulic system in the hydraulic station.

First of all, the hydraulic oil in the oil tank should always be kept at a normal level.

When the capacity of pipeline and oil cylinder is large, sufficient oil shall be put in first. After the engine is started, because the oil enters the pipeline and oil cylinder, the oil level will drop, and even the oil filter will expose the oil level, so it is necessary to refuel again. Leakage may also occur in the process of application. The oil tank shall be equipped with a level gauge for regular investigation and recovery of oil.

2、 Precautions when using outdoor hydraulic equipment.

1. The outdoor temperature changes sharply with the seasons, and try to use oil with large viscosity index.

2. Due to temperature changes, the water vapor in the oil tank of the hydraulic system will condense into water drops. In winter, it should be checked once a week and immediately removed.

3. Because the dirt outside the house simply enters the oil, the oil should be changed frequently.

3、 Precautions for engine hydraulic oil pump.

1. Fill the pump with oil.

2. Check whether the rotation direction is correct.

3. Whether the entrance and exit are relative.

4. Try rolling with your hands.

5. Check the suction side for air leakage.

6. Start running within the specified speed.

4、 Precautions for low temperature engine oil pump.

1. When starting the oil pump in cold weather or in the environment, start and stop it, and improve the oil temperature by reciprocating. After the oil pressure equipment operates flexibly, it can enter into formal operation.

2. It is recommended to heat the oil tank with a heater for a short time to improve the oil temperature. But at this time, the pump and other equipment are still very cold, as long as the oil is hot, simple problems. Be careful.

Verb (short for verb) Others.

1. Unload the relief valve when the oil pump starts and stops.

2. The regulating pressure of the relief valve shall not exceed the higher pressure of the hydraulic system.

3. Try to keep the voltage of solenoid valve stable, otherwise the coil may overheat.

4. Wear resistant parts, such as sealing rings, should always have spare parts for timely replacement.